Synthesis and performances for treating oily wastewater produced from polymer flooding of new demulsifiers based on polyoxyalkylated N,N‐dimethylethanolamine

Usually, oily wastewater produced from polymer flooding (OWPF) was treated by cationic polymer in oilfield. In this paper, six block copolymers of ethylene oxide and propylene oxide were prepared by using N,N‐dimethylethanolamine (DMEA) as the acceptor (DMEA‐mnp and DMEA‐mnpq, n:m:p:q represented the weight ratio of different blocks). Most of DMEA products could perform well for treating OWPF, especially DMEA1231. Their performances were mainly affected by temperature. The reason of increasing oil removal performance of DMEA1231 with temperature was the decrease of interfacial dilational modulus (ε) with increasing temperature. When temperature raised up to 55°C, the ε of DMEA1231 had the minimum (1.5 l mN/m). Therefore, the OiW had the minimum (90 mg/l). Because DMEA1231 had the best performance, its flocculation kinetics was studied systemically. The results showed that the optimum condition for DMEA1231 was as follows: dosage was 300 mg/l, temperature was 55°C, stirring speed was 200 rpm and stirring time was 5 min. At last, the offshore oil field test was carried out to check the DMEA1231 performance. The result showed that at the optimum condition, DMEA1231 could perform as well as the cationic polymer. The most important thing was that flocs of DMEA1231 were not viscous and floated on the surface of the water. The results obtained by this paper provide a good choice for the treatment of OWPF in offshore oilfield to avoid the formation of viscous flocs. Copyright © 2014 John Wiley & Sons, Ltd.     

Solution or Gas Phase? Oxidation and Radical Formation in Electrospray Ionization Mass Spectrometry (ESI MS)

The relationship between one‐electron (e^?) oxidation processes and the formation of radical cations of endogenous and exogenous compounds in vivo is of considerable interest. This paper reports on the experiments that allow FTICR mass spectrometric (MS) detection of ion signals that are consistent with the formation of radical cations of caffeine (CA) and theophylline (TP) during electrospray ionization (ESI) in ESI FTICR MS and in on‐line electrochemistry (EC)/ESI FTICR MS in positive mode. Significantly, the signals of the radicals of CA^?+ and TP^?+can be enhanced by simple modifications of the operating conditions in ESI MS, facilitating investigations of radical formation and related reactions.     

Square‐Wave Voltammetry of Electroinactive Surfactants

Under the influence of previously published and some new theoretical results, potential‐ dependent adsorption and desorption of model electroinactive surfactants Triton X‐100 (T‐X‐100 or polyethylene glycol p‐(1,1,3,3‐tetramethylbutyl)‐phenyl ether) and sodium dodecyl sulfate (SDS) on the static mercury drop electrode (SMDE) were studied by square‐wave voltammetry (SWV). Although (according to the theory) the resulting current – potential curve should consist of two highly separated peaks, only desorption signal could be seen on each experimentally obtained voltammogram, most probably because of the limitations concerning the available potential range. Different properties of the recorded peak are in good agreement with the theory indicating that square‐wave voltammetry could be treated as a potential tool for tensammetric studies of electroinactive surface active substances.     

Construction of a Novel Carbon Paste Clarithromycin Sensor for Low Level Concentration Measurement,Applications to Pharmaceutical and Biological Analysis

A potentiometric carbon paste sensor was fabricated for determination of clarithromycin based on incorporation of the ion association complex of the clarithromycin‐phosphotungstate. The proposed sensor exhibited a Nernstian slope of 59.2±0.3 mV per decade for clarithromycin over a wide concentration range of 7.4×10^?7 to 1.5×10^?3 M, with a low detection limit of 5.0×10^?7 M. The proposed sensor manifested advantages of very fast response, long life time and, most importantly, excellent selectivity for clarithromycin relative to a wide variety of common foreign inorganic cation, and also biological species. The sensor was successfully applied to determine clarithromycin in clarithromycin tablet, blood serum and urine samples. The inclusion complex formation between β‐cyclodextrin and clarithromycin was studied by the proposed sensor. The influence of the temperature on the response of the sensor was investigated and the temperature coefficient of the sensor was calculated.     

Electrocatalytic Determination of Hydroxylamine in the Presence of Thiosulfate in Water and Wastewater Samples Using a Nanostructure Modified Carbon Paste Electrode

In this research, we report the preparation of a high sensitive voltammetric sensor for electrocatalytic determination of hydroxylamine (HX) in the presence of thiosulfate (TS). We describe the synthesis and characterization of CdO nanoparticles (CdO/NPs) with transmission electron microscopy (TEM) and X‐ray diffraction (XRD) methods. At an optimum condition, the two peaks are separated ca. 0.58 and 0.92 V for HX and TS at the surface of the proposed sensor. Square wave voltammetry (SWV) of HX exhibited two linear dynamic ranges with a detection limit (3σ) of 0.06 µmol L^?1. The propose sensor was used for determination of HX in water samples.     

Prediction models for the key mechanical properties of EPDM/PP blends as affected by processing parameters and their correlation with stress relaxation and phase morphologies

The optimum condition of processing parameters (mixing temperature, rotor speed, fill factor, and blend ratio) and prediction models for the best key mechanical properties of ethylene propylene diene terpolymer/polypropylene thermoplastic vulcanizates (EPDM/PP TPVs) was investigated by using the Taguchi's optimization technique and data analysis. The results reveal that all of the processing parameters affected significantly the mechanical properties of the EPDM/PP TPVs, but specifically the blend ratio contributed more than 90% in effect size on tensile strength and tension set. There were three main factors, the mixing temperature, the fill factor, and the blend ratio, influencing the elongation at break. Furthermore, the mathematic models were effective and reliable in predicting the properties of TPVs. The correlation of mechanical properties, stress relaxation, and phase morphologies of the TPVs prepared from the predicted models was also investigated. It can be summarized that the morphological structure and stress relaxation of the TPVs were strongly governed by the EPDM content in the blend ratio. That is, the higher the EPDM content, the better phase morphology having smaller size of the vulcanized EPDM particles distributed in the PP matrix and the higher rate of stress relaxation. Moreover, these two properties were then principally pushing the mechanical characteristics of the EPDM/PP TPVs. Copyright © 2015 John Wiley & Sons, Ltd.     

Mass spectrometry detection of minor new meridianins from the antarctic colonial ascidians Aplidium falklandicum and Aplidium meridianum

Taking into account the broad biological activities found in the meridianin indole alkaloids isolated to date, we have re‐examined the organic extracts of an Antarctic collection of the tunicates Aplidium meridianum and A. falklandicum (Chordata: Ascidiacea) by HPLC in conjunction with a high‐resolution mass spectrometer (HPLC‐MS). A new set of analogs of meridianins A–G has been detected, and their structures are proposed on the basis of the molecular formulae identified by LC‐HRMS analysis using a C18 column with a gradient of water/acetonitrile and an LTQ‐FT‐MS Orbitrap detector. Remarkably, dimers derived from meridianin A and from meridianin B or E were also detected. Our findings provide further evidence of the broad variability within the meridianin‐like derivatives of this highly bioactive alkaloid family. Copyright © 2015 John Wiley & Sons, Ltd.